Carbon, tar, antifreeze and other chemicals can not move through the epoxy floor surface, because these floors are non-porous. Therefore these chemicals would remain on top of the coating which makes it extremely easy to clean epoxy flooring. click for more info about us.
The stronger you preserve the epoxy flooring, the longer it will last, as do most surfaces. Epoxy floors will regularly remove dust , dirt and garbage, because although the floors are non-porous, certain contaminants can serve as abrasives. If you don’t often brush them up, they can cause scratches on the pavement as traffic passes over them.
Depending on the floor size, you may need professional help but if you follow the steps below, most epoxy can be washed quite easily:
1. Spray the dirt off the floor or brush it up. If you are operating in a workshop or on a patio that will drain quickly, you should pre-rinse the floor with a hose to scrub big pieces of debris such as leaves and clumps of filth. If you are not washing a floor with good drainage, brush the dirt out with a broom instead. You can also use a blower to clean mud and leaves clear.
Epoxy surfaces can then be mopped in a mixture of 1/2 cup to 1 gallon of hot water with any kitchen detergent or dish cleaner. Rinse often to clean all the dirt from your mop and the soap scum from your tile. Use a rayon mop or any other synthetic fabric: mops made of natural fabrics tend to stick to epoxy flooring, leaving pieces behind and then causing problems. Steam mops do an exceptional job too.
2. Using degreaser to degrease cold water. Sprinkle a degreaser with cold water and spray it over with a deck cloth for full coverage. The brush should be soft and should have non-abrasive bristles. Keep the degreaser on the floor for the amount of time the manufacturer recommends. Don’t leave the degreaser on too long, because after a certain length of time the chemical compounds in it may damage your floor. Dirt and grime can continue to bead up due to the epoxy floor properties , making removal simple.
3. Repeat and rinse. To get rid of the scum generated by the degreaser and the debris you scrubbed out, spray the whole floor with warm water. Rinse the concrete a second time to guarantee there there is no residual left behind. Flush all the water and use a wet / dry shop cleaner to clear the epoxy board. When you don’t have a wet / dry shop cleaner, you should use a squeegee, then just move the water down your deck or garage drain. Be sure you clean all the water, since keeping your floor damp will render it slick, and it also provides a place for rising mildew and molds. Epoxy floors are equivalent in terms of quality and aesthetics to certain forms of flooring. When you use the tips provided in this post, epoxy is also really simple to clean.